![mitsumi quick disk transport mitsumi quick disk transport](https://m.media-amazon.com/images/I/61hnqJQfkoL._AC_UL800_QL65_.jpg)
![mitsumi quick disk transport mitsumi quick disk transport](http://blogs.bodleian.ox.ac.uk/wp-content/uploads/sites/161/2011/04/DSCF30071.jpg)
The "1.44 MB" value for the 3½-inch HD floppies is the most widely known example where the "M" prefix is peculiar to the context of the disk drive and represents neither a decimal million nor a mebibyte 2 ^20. This led to an impure combination of decimal multiples of sectors and binary sector sizes. Individual formatted sector lengths are arbitrarily set as powers of 2 (256 bytes, 512 bytes, etc.), and disk capacity is naturally calculated as multiples of the sector size. Unlike semiconductor memory, which doubled in size each time an address pin was added to an integrated circuit package and so naturally favored counts that were powers of two, the capacity of a disk drive was the product of the sector size, number of sectors per track, number of tracks per side, (and in hard drives, the number of disk platters in the drive). Mixtures of decimal SI-style prefixes and binary record lengths required care to properly calculate total capacity. The amount of capacity lost to this overhead depends on the application of the drive and is beyond the manufacturer's control. The formatted capacities of floppy disks is less than the unformatted capacity, which does not include the sector and track headings required for use of the disk. Also in double density mode the standard MFM encoding was modified from the standard to prevent false header detection in data.Ībbreviations: DD = Double Density QD = Quad Density HD = High Density ED = Extended Density LS = Laser Servo HiFD = High capacity Floppy Disk SS = Single Sided DS = Double Sided The RX02 mode is not compatible with other standard drives since the headers are always in single density mode but the data is written in double density mode. NOTE: "RX02 8 inch Floppy Drive Information". SS = Single Sided SD = Single Density DD = Double Density TPI = Tracks per Inch BPI = Bits per Inch SS = Single Sided DS = Double Sided SD = Single Density DD = Double Density N/A = Not Applicable TPI = Tracks per Inch BPI = Bits per Inchĭigital Equipment Corporation used the following formats on 8-inch disks: Category This is a list of 8-inch floppy diskette formats as introduced by IBM.